ASTM D 2646-2002 绒头纱线地板覆盖物的衬布特性的标准试验方法

上一篇: ASTM D 5219-2002 服装度量用人体尺寸的相关标准术语
下一篇: ASTM D 2136-2002 涂层织物的低温弯曲标准试验方法

Product Code:SAE J1962
Title:Diagnostic Connector Equivalent to ISO/DIS 15031-3:December 14, 2001
Issuing Committee:Vehicle E E System Diagnostic Standards Committee
Scope:This document supersedes SAE J1962 FEB1998, and is technically equivalent to ISO/DIS 15031-3:December 14, 2001. This document is intended to satisfy the requirements of an OBD connector as required by U.S. On-Board Diagnostic (OBD) regulations. The diagnostic connection specified in this document consists of two mating connectors, the vehicle connector and the external test equipment connector. This document specifies: a. The functional requirements for the vehicle connector. These functional requirements are separated into four principal areas: connector location/access, connector design, connector contact allocation, and electrical requirements for connector and related electrical circuits, b. The functional requirements for the external test equipment connector. These functional requirements are separated into three principal areas: connector design, connector contact allocation, and electrical requirements for connector and related electrical circuits.Differences from ISO Document. The ISO 15031-3 document is intended to satisfy the requirements of OBD requirements in countries other than the U.S., and includes functionality not required or not allowed in the U.S. Notable exceptions are: a. Proposed U.S. OBD regulations specify a connector location that is more restrictive than specified in this document. b. Proposed U.S. OBD regulations do not allow greater than 20 V at the SAE J1962 connector. Only the Type A connector as defined in this document is allowable. Differences between the documents are highlighted in the technical requirements sections of this document. Deleted text is highlighted with strikethrough and new text is highlighted with bold italic. NOTE - To maintain equivalency of the documents, a comma is used as a decimal marker for numeric values in this document.MIL-STD-1339C, DEPARTMENT OF DEFENSE STANDARD PRACTICE: FITTING OUT PROCEDURES-SHIPS (27 FEB 1990)., The purpose of this military standard is to standardize contractor related fitting out procedures and to definitize contractor fitting out responsibilities.